Skylight reflashing
A new flashing kit is installed around the frame backed by ice and water membrane.
A Bloomingdale roofer can repair skylight flashing, glass, seals and frames, once it is clear whether the water is a leak or condensation. One call to (862) 356-0010 reaches a nearby roofer who handles skylight repair.
Water around a skylight almost always gets in at the joint between the frame and the roof. Every skylight relies on a set of flashing pieces, with step flashing woven into the shingles along the sides and solid pieces across the top and bottom. Sealant that was smeared over the joint years ago dries out and cracks, letting water in on the next hard rain.
Before anything gets torn apart, it is worth ruling out condensation. Warm, humid indoor air hits the cold glass in winter, condenses and runs down onto the frame and drywall, which looks just like a leak. A haze trapped between the panes points to a failed glass seal, not a leak, and calls for glass work instead of flashing work.
A few details help narrow it down before the visit. Write down when the dripping happens, whether the glass fogs inside or between the panes and whether the stain is at the top or bottom of the shaft. Say whether it is a venting or fixed unit, and whether it went in with the current roof or an older one.
Skylight Repair is often paired with skylight installation and flashing repair, depending on the cause.
Dealing with this in Bloomingdale, NJ right now? Call (862) 356-0010 to talk to a local roofer.
Call nowGood skylight work separates leaks from condensation first.
The inspection starts below, checking the frame, the shaft drywall and the glass for signs of condensation versus leaking. A moisture meter helps map how far the water has spread.
Up top, the flashing kit, the seals and the shingles around the frame are checked for gaps, rust, lifted pieces and old caulk. Controlled water testing can pin down which side lets water in.
The shingles around the skylight are lifted, the old flashing removed and new flashing installed in correct laps. This is the repair that fixes most skylight leaks.
Failed insulated glass, a cracked pane or a crazed dome is replaced, and worn gaskets and seals are renewed. Some units allow the sash or glass to be replaced without touching the flashing.
After the leak is fixed, stained or soft drywall in the light well is repaired. Insulation around the shaft is checked, since thin insulation adds to condensation.
A new flashing kit is installed around the frame backed by ice and water membrane.
Cracked, crazed or yellowed plastic domes are replaced which restores light and seals out rain.
Water damage around the skylight opening is cleaned up and the shaft is insulated if needed.
Insulated glass with a failed seal is replaced to restore clarity and insulation.
Stuck sashes and failed operators are fixed so the unit opens and seals properly.
Fixing a skylight leak means tracing the water to the flashing, the curb, the seals or the shingles around the unit. Most leaks are fixed by reflashing the sides and head, adding ice and water membrane and cleaning out the debris pocket above the skylight. Caulk alone rarely lasts more than a season or two on a skylight.
A skylight leak in Bloomingdale that only shows up in wind-driven rain often points to a side flashing or a loose shingle beside the unit. When the skylight is nearly as old as the roof, the roofer may suggest replacing the unit and flashing together, since the parts wear out at the same time. Ask which option saves you from opening the roof twice.
When the glass or dome is the problem but the frame and flashing are sound, replacing just the glazing makes sense. Most modern skylights have a double-pane insulated unit, often with laminated inner glass for safety. Plastic domes on older curbs can usually be swapped without touching the roof.
For Bloomingdale homes, the age of the unit decides whether new glass is worth it. Many units let the sash or glass come out without disturbing the flashing, but older or discontinued ones may not. Low-E coated glass cuts summer heat and keeps the inside pane warmer in winter.
Around Bloomingdale, most skylight leaks trace back to worn flashing or sealant that has dried out over the years. Across Bloomingdale and nearby communities including Wanaque, Butler, Riverdale and Pompton Lakes, skylights that were left in place during an earlier reroof are often the ones that leak first, and catching a drip early saves the drywall and insulation around it.
Need skylight repair around Bloomingdale? Call (862) 356-0010 for a Bloomingdale roofer who serves the towns around it too.
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Bloomingdale is busiest after a hard winter and before the next one.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Local roofers see the same roofs and storm damage across Bloomingdale and nearby towns.
Ask your questions before you agree to anything.
More questions? Call (862) 356-0010
New skylight installation with proper framing, flashing and a finished light shaft, sized and placed for the room below.
Learn moreFlashing repairs at the joints where most roof leaks start, so water runs onto the shingles instead of into the wall.
Learn moreFinding where water gets through the roof and sealing it at the source, with the damage underneath checked too.
Learn moreTracing hidden roof leaks with attic checks, moisture meters, hose testing and infrared scans, so the repair goes in the right place the first time.
Learn moreLooking for something else?
See all roofing servicesCall (862) 356-0010 for a local roofer in Bloomingdale and nearby towns.