Local roofersFree to callNo forms to fill out
Serving Bloomingdale and nearby towns
Menu
Call (862) 356-0010
Tile Roofing

Tile Roof Repair Bloomingdale, NJ

A Bloomingdale tile roofer can repair clay and concrete tile roofs one section at a time, from a single cracked tile to relaying the tile over a leaking valley. Call (862) 356-0010 to reach a local roofer who works on tile.

Tile roof repair starts with knowing that the tiles are not the waterproof layer. Some water always gets under tile in a hard storm, and the felt or synthetic underlayment below is the layer that carries it to the eaves.

The repairs a tile roof needs are fairly predictable. Broken tiles from people walking the roof or from falling branches, tiles that slid down after a fastener failed and ridge caps with crumbling mortar make up most calls.

Tile breaks easily under a misplaced foot, so walking a tile roof to look for damage often causes more damage than it finds, and wet tile is slippery as well. Note where stains show inside, whether the leak follows wind-driven rain and whether the tile is clay or concrete, flat or curved, since that helps the roofer bring matching tile.

Tile Roof Repair is often paired with tile roof replacement and tile roof inspection, depending on the cause.

Dealing with this in Bloomingdale, NJ right now? Call (862) 356-0010 and describe the problem to a roofer who works in Bloomingdale.

Call now
The process

The tile roof repair process

A good tile repair fixes the leak without breaking more tile on the way.

  1. Look before walking

    Before walking the roof, the roofer looks from a ladder, from the attic and sometimes with a drone to plan a route. On the roof, weight goes on the lower part of each tile where it overlaps the one below, or on foam pads that spread the load.

  2. Find the entry point

    Since the leak may start several feet uphill from the stain, the roofer lifts tiles near the suspected spot to look at the underlayment and flashing beneath.

  3. Swap damaged tile

    The roofer removes broken pieces, lifts the overlapping course and fastens a matching replacement tile in the same position. For older roofs, matching tile may come from salvage stock or from a hidden area of the same roof.

  4. Refasten loose tile

    Slipped tiles are realigned and fastened again with corrosion resistant fasteners or clips so the problem does not come back.

  5. Fix the layer underneath

    A section with failed underlayment gets a lift-and-relay, which reuses the existing tile over fresh underlayment. It is the most involved tile repair, but it keeps the original tile on the roof.

What is included

Common tile roof repairs

Partial tile relay

Tiles are lifted, new underlayment goes down and the same tiles go back without replacing the whole roof.

Valley repair

Valleys are cleared and their metal liners repaired which handles leaks the tiles cannot stop.

Tile refastening

Shifted tiles are reset in their rows with hardware that resists rust.

Hip cap rebedding

Ridge caps are secured with fresh mortar or a dry ridge system so the top of the roof stays sealed.

Broken tile replacement

Broken tiles are taken out and new ones fitted in their place so the roof sheds water again.

Related service

Clay Tile Roof Repair Bloomingdale, NJ

Clay tile is one of the longest lasting roofing materials, and on many older homes the original tiles are still sound. The weak point is impact: clay tile cracks under a careless step or a dropped limb.

The hardest part of clay tile roof repair in Bloomingdale is often finding a match. When a profile is out of production, salvaged tile or tiles borrowed from an out-of-sight area fill in on the visible slopes.

Related service

Concrete Tile Roof Repair Bloomingdale, NJ

Concrete tiles are made from sand and cement and wear differently from clay. Surface erosion, faded color and moss growth are typical as concrete tile ages, and the tile soaks up more moisture over time.

Concrete tile roof repair in Bloomingdale usually means replacing cracked tiles, resetting slipped ones and dealing with the underlayment beneath worn sections. If moss is part of the problem, a soft wash treatment is far easier on the tile than a pressure washer.

Related service

Tile Roof Leak Repair Bloomingdale, NJ

When a tile roof leaks, the real failure is usually in the underlayment, a valley or a flashing, with the tiles only part of the story. Look for trouble at valleys, sidewalls, skylights and pipe penetrations, along with underlayment that has dried out and torn. It is common for a tile roof to stay dry in gentle rain and leak only when wind pushes water under the tiles.

For a tile roof leak in Bloomingdale, the roofer works back from the ceiling stain to the spot where water first gets under the tile. Until the repair, catch drips in a bucket and keep water away from electrical fixtures, switching off that circuit at the panel if it is safe to do so.

Local help

Tile Roof Repair Near Me

Tile roofs around Bloomingdale range from clay roofs that have been up for generations to concrete tile on newer homes. From Bloomingdale out to Wanaque, Butler, Riverdale and Pompton Lakes, storms that knock limbs onto roofs and years of sun on the underlayment are what send most tile roofs in for repair. Getting broken tiles replaced promptly keeps sun and water off the underlayment and stretches the life of the whole roof.

For tile roof repair in Bloomingdale, NJ or nearby towns like Wanaque, Butler, Riverdale and Pompton Lakes, call (862) 356-0010 to reach a roofer who covers your street.

How the weather here affects roofs around Bloomingdale

Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Bloomingdale, NJ have the roof checked in the fall and again after the snow melts.

Why call

Why not wait

Drier ceilings

A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.

Local knowledge

Local roofers see the same roofs and storm damage across Bloomingdale and nearby towns.

Clear next steps

Ask the roofer about the cause, the options and the estimate before work starts.

Tile Roof Repair FAQ

Should I repair or replace my tile roof?
What decides it is the condition of the underlayment, not the tile. A few cracked tiles or one leaking flashing point to a repair. Once the underlayment is worn out across the roof, a full relay or replacement is the better plan. Call (862) 356-0010 to talk it through with a roofer.
How can a tile roof leak with no broken tiles?
Tile sheds most of the rain, but the underlayment beneath it is what keeps the house dry. Old underlayment can crack apart even under perfect tile, letting that water through. Flashing at valleys, walls and pipes is the other usual suspect.
Is it safe to walk on a tile roof?
Stepping on tile is the most common way tiles get broken. Even experienced roofers step only on the overlapped edges and sometimes crack a tile anyway. Never go up when the tile is wet, icy or covered in moss.
Is it possible to replace just a few broken tiles?
Individual tiles can be replaced without disturbing the rest of the roof. Each replacement is secured with a fastener, clip or adhesive suited to the roof.
How long does a tile roof last?
The tile itself is very long lived, with clay often lasting well past fifty years and concrete tile lasting decades. The underlayment underneath is the limit, often wearing out somewhere around twenty to thirty years depending on the material and climate.

More questions? Call (862) 356-0010

Other services that may help

  • Tile Roof Replacement

    Replacing a worn tile roof, either by relaying the existing tile over new underlayment or by switching to new tile, so the layers under the tile last as long as the tile.

    Learn more
  • Tile Roof Inspection

    A close look at the tile, underlayment, flashing, valleys and attic of a clay or concrete tile roof, without breaking tile in the process.

    Learn more
  • Roof Leak Repair

    Finding where water gets through the roof and sealing it at the source, with the damage underneath checked too.

    Learn more
  • Flashing Repair

    Flashing repairs at the joints where most roof leaks start, so water runs onto the shingles instead of into the wall.

    Learn more

Looking for something else?

See all roofing services

Need tile roof repair in Bloomingdale, NJ?

Call (862) 356-0010 for a local roofer in Bloomingdale and nearby towns.

Talk to a local roofer(862) 356-0010Call now

Free to call. No forms to fill out.

Call (862) 356-0010